Victron Black front for EV Charging station NS
Black front cover for EV charging station NS
RS485 to USB interface to connect ET112, ET340 and EM24 to Victron GX Devices
A cable to connect Digital Multi Control, Phoenix Inverter Control, Interface MK3-USB, VE.Bus connections between multiple VE.Bus devices and to make VE.Bus and VE.Can connections to a GX device.
SmartSolar Control display
Victron Orion-Tr 24/12-10 (120W) DC-DC converter Non isolated
Completely encapsulated: waterproof, shockproof and ignition protected
Water, oil or dirt will not damage the Orion IP67 DC-DC Converter. The casing is made of cast aluminium and the electronics are moulded in resin.
Victron M8 circular connector Male/Female 3 pole cable 1m (bag of 2)
Victron Current Transformer 100A:50mA for MultiPlus-II (5m) Wire-end
Victron BlueSolar PWM-LCD&USB 12/24V-20A
Solar charge controller
BlueSolar PWM-LCD&USB
- Liquid Crystal Display
- Two 5 Volt USB outputs
- Lighting control function, fully programmable
- Three stage battery charging (bulk, absorption, float), fully programmable
- Load output with low voltage and manual disconnect (programmable)
- Load output protected against over load and short circuit
- Protected against reverse polarity connection of the solar panels and/or battery
BlueSolar PWM DUO-LCD&USB
All the above-mentioned functions, plus:
- Charges two separate batteries
- Programmable charge current ratio
- External Temperature sensor
CONTACT US FOR QUANTITY DISCOUNTS / INSTALLER / RESELLER PRICING
info@createenergy.co.za / 0118880410
Victron Orion IP67 24/12-10A (120W) DC-DC Converter Non Isolated
Completely encapsulated: waterproof, shockproof and ignition protected
Water, oil or dirt will not damage the Orion IP67 DC-DC Converter. The casing is made of cast aluminium and the electronics are moulded in resin.
Victron M8 circular connector Male/Female 3 pole cable 2m (bag of 2)
Victron BATTERY SWITCH ON/OFF 275A
- Max.continuouscurrent: 275A
- One minute rating: 450 A
- Cranking rating: 1200 A
- Voltage rating: Up to 60VDC
Victron Wall mounted enclosure for Color Control GX and BMV or MPPT
Victron Pre-Charge Cable (Resistor)
The Pre-charge Cable allows internal capacitors of an inverter, inverter/charger or MPPT to be pre-charged via the DC terminals before connecting the battery.
Victron BatteryProtect 12/24V-65A
The BatteryProtect disconnects the battery from non essential loads before it is completely discharged (which would damage the battery) or before it has insufficient power left to crank the engine.
The BatteryProtect is a uni-directional device. It can only deal with current in one direction, so either current to a load, or current from a charger, but not both currents at the same time. In addition to this, current only can only flow from the Battery terminal to the Load terminal. In case of use with a load, the battery connects to the Battery terminal, and in case of use with a charger, the charger connects to the Battery terminal.