Victron BatteryProtect 12/24V-220A
The BatteryProtect disconnects the battery from non essential loads before it is completely discharged (which would damage the battery) or before it has insufficient power left to crank the engine.
The BatteryProtect is a uni-directional device. It can only deal with current in one direction, so either current to a load, or current from a charger, but not both currents at the same time. In addition to this, current only can only flow from the Battery terminal to the Load terminal. In case of use with a load, the battery connects to the Battery terminal, and in case of use with a charger, the charger connects to the Battery terminal.
Victron BCD 402 2 batteries 40A (combiner diode)
Diode Battery Combiners are used to guarantee continuous DC power to mission critical equipment, such as an electronic engine control system. With a Diode Battery Combiner two or more DC power sources can be used in parallel to supply the mission critical load. Failure of one source will not interrupt power to the critical load.
Delkor NS70L/80D26L
12V
70Ah (Same size as the 65Ah)
Semi-Sealed Maintenance Free
- Calcium maintenance free dual purpose battery
- Low-Resistance envelope separators
- High strength polypropylene case
- Heat Sealed covers
- Exclusive patented liquid gas separator
- Built in Hygrometer
Victron Current Transformer 100A:50mA for MultiPlus-II (20m)
Victron M8 circular connector Male/Female 3 pole cable 1m (bag of 2)
Victron Orion-Tr 48/48-8A (380W) Isolated DC-DC converter
Remote on/off
The remote on/off eliminates the need for a high current switch in the input wiring. The remote on/off can be operated with a low power switch or by for example the engine run/stop switch (see manual).
All models are short circuit proof and can be paralleled to increase output current. An unlimited number of units can be connected in parallel.
IP43 protection
When installed with the screw terminals oriented downwards.
Screw terminals
No special tools needed for installation.
Input fuse
On 12V and 24V input models only.
Victron Orion-Tr 24/24-12A (280W) Isolated DC-DC converter
Remote on/off
The remote on/off eliminates the need for a high current switch in the input wiring. The remote on/off can be operated with a low power switch or by for example the engine run/stop switch (see manual).
All models are short circuit proof and can be paralleled to increase output current. An unlimited number of units can be connected in parallel.
IP43 protection
When installed with the screw terminals oriented downwards.
Screw terminals
No special tools needed for installation.
Input fuse
On 12V and 24V input models only.
Victron Orion-Tr 24/24-5A (120W) Isolated DC-DC converter
Remote on/off
The remote on/off eliminates the need for a high current switch in the input wiring. The remote on/off can be operated with a low power switch or by for example the engine run/stop switch (see manual).
All models are short circuit proof and can be paralleled to increase output current. An unlimited number of units can be connected in parallel.
IP43 protection
When installed with the screw terminals oriented downwards.
Screw terminals
No special tools needed for installation.
Input fuse
On 12V and 24V input models only.
Victron Orion-Tr 24/12-20A (240W) Isolated DC-DC converter
Remote on/off
The remote on/off eliminates the need for a high current switch in the input wiring. The remote on/off can be operated with a low power switch or by for example the engine run/stop switch (see manual).
All models are short circuit proof and can be paralleled to increase output current. An unlimited number of units can be connected in parallel.
IP43 protection
When installed with the screw terminals oriented downwards.
Screw terminals
No special tools needed for installation.
Input fuse
On 12V and 24V input models only.
Victron Orion-Tr 12/12-30A (360W) Isolated DC-DC converter
Remote on/off
The remote on/off eliminates the need for a high current switch in the input wiring. The remote on/off can be operated with a low power switch or by for example the engine run/stop switch (see manual).
All models are short circuit proof and can be paralleled to increase output current. An unlimited number of units can be connected in parallel.
IP43 protection
When installed with the screw terminals oriented downwards.
Screw terminals
No special tools needed for installation.
Input fuse
On 12V and 24V input models only.
Victron Skylla-TG 24/50 GMDSS 120-240V
The Victron Skylla-TG 24/30 and 24/50 GMDSS Chargers have been designed to provide all required monitoring and alarm data. Both the battery and the GMDSS system are connected directly to the charger. Data and alarms are displayed on a digital panel (VE.Net GMDSS panel, to be ordered separately). A standard eight wire UTP cable connects the charger to the panel.
- 120-240VAC
- 24VDC charger
- 30A charger
- 1 full output rated
Victron EasySolar-II 24/3000/70-32 MPPT 250/70 GX
All-in-one solar power solution
The Victron EasySolar-II GX integrates the following elements:
• A MultiPlus-II inverter/charger
• A SmartSolar MPPT -Tr solar charge controller
• A GX device with a 2 x 16-character display.
These elements come prewired together inside a single unit. This greatly simplifies most installations, saving time and money.
24VDC, 3000VA
70A Charger, 32A Transfer Switch
250VDC 70A MPPT
Victron Phoenix IP43 Smart Charger 24 V / 16 A (1+1) 120 - 240V ac
</ = 16 A Main House Battery Charger Plus </= 4 A Battery Maintainer for 24 V Primary Cranking Battery
Wide AC Input Range 120-240 Vac
Adjustable DC Output Current Setting
Ready for Parallel and Redundant Operation
Natural Convection Cooling
Adaptive 5 Stage Charge Algorithm
Less than 1 mA Self Consumption
Full Rated Output up to 40 Deg C
IP43 Degree of Ingress Protection
Requires CE 13 "Kettle" Plug - Not Included
Victron EV Charging Station NS
The EV Charging Station NS has three-phase and single-phase capabilities. It delivers a maximum of 22kW AC in three-phase or 7.3kW in single-phase mode.
The device is technically identical to the EV Charging Station, but with a new, modern design available in 3 colours and without the built-in LCD screen. Initial setup, configuration and monitoring is done from VictronConnect via Bluetooth and/or the integrated web interface via a WiFi Access Point or a WiFi LAN.
The charger can be fully integrated with and remotely controlled via a Victron Energy GX Device and VRM.
Not only does this EV Charging Station NS fully integrate with a Victron Energy GX device and VRM, if you have solar (within the Victron ecosystem), it can also be set up to allow excess energy from the sun to directly charge your vehicle. Manual and scheduled modes offer even more flexibility to respond to the needs of the EV depending on the system.
It has a fully programmable RGB light ring around the charging port that displays different light effects depending on the current status (disconnected, charging, charged, etc.) to quickly determine the device status.
Victron Anti-Islanding Box Ziehl UFR1001E 63A single and three phase
The Anti-Islanding Box 63A single and three phase is a combination of an anti-islanding device, the Ziehl UFR1001E, two in-line contactors and main circuit breaker. It is suitable for both single phase or 3 phase systems. It is rated up to 63A per phase and all parts are conveniently housed in an IP65 rated enclosure.
Victron Phoenix Inverter 12/800 230V VE.Direct SCHUKO
Inverter
BSL Batt B-LFP48-172E 48V (51.2V), 8.8kWh, 172Ah Lithium Iron Battery
Features:
- 51.2V
- 172Ah Capacity
- 172A Max Discharge
- Designed to discharge to 80% DOD
- 8800Wh, 8.8kWh (6560Wh / 7.04kWh Usable at 80% DOD)
- 10 Year Warranty
- 15-18 Years Designed Service Life
- +-4000 Cycles at 80% DOD
Email: info@createenergy.co.za or telephone: +(27) 11 888 0410
VE.Direct cables, use to connect BMV-70x and low power MPPTs to a Victron GX Device
The VE.Direct cable is available in different lengths. There is a straight and 90 degree angle model. Please check our pricelist for all available models.
VE.Direct cables, use to connect BMV-70x and low power MPPTs to a Victron GX Device
The VE.Direct cable is available in different lengths. There is a straight and 90 degree angle model. Please check our pricelist for all available models.
BSL Batt B-LFP48-125E 48V (51.2V), 6.4kWh, 125Ah Lithium Iron Battery
Features:
- 51.2V
- 125Ah Capacity
- 125A Max Discharge
- Designed to discharge to 80% DOD
- 6400Wh, 6.4kWh (5120Wh / 5.12kWh Usable at 80% DOD)
- 10 Year Warranty
- 15-18 Years Designed Service Life
- +-4000 Cycles at 80% DOD
Email: info@createenergy.co.za or telephone: +(27) 11 888 0410
Victron Phoenix Inverter 24/800 230V VE.Direct SCHUKO
Inverter
Victron Phoenix Inverter 48/1200 230V VE.Direct IEC
Inverter
Victron MultiPlus Compact 12/1600/70-16 230V VE.Bus
Multifunctional
Pure Sine Wave Inverter / Charger, adaptive charging, hybrid PowerAssist technology, plus multiple system integration features.
1600VA / 1300W @ 25°C
12VDC, 70A Charger, Lithium Ion battery compatible
16A Transfer Switch
230VAC
Victron MultiPlus 12/3000/120-50 230V VE.Bus
Multifunctional
Pure Sine Wave Inverter / Charger, adaptive charging, hybrid PowerAssist technology, plus multiple system integration features.
3000VA / 2400W @ 25°C
12VDC, 120A Charger, Lithium Ion battery compatible
50A Transfer Switch
230VAC