Use this cable to connect a CAN-bus enabled battery, not from Victron, to a Victron system.
Suitable for LBSA and Volta to Victron GX Device
Victron Smart BatteryProtect 12/24 V 100 A
Smart BP-100
The Smart BatteryProtect disconnects the battery from non-essential loads before it is completely discharged (which would damage the battery) or before it has insufficient power left to crank the engine.
When using Bluetooth to program the Smart BatteryProtect any required engage/disengage levels can be set.
Alternatively, one of nine predefined engage/disengage levels can be set with the programming pin (see manual).
If required, Bluetooth can be disabled.
25mm2 Cable Size to 8mm Crimping Lug
Victron SmartSolar MPPT 150/60-Tr
12V/24/48V
Solar charge controller
150VDC / 70A
12/24/48V Battery
CONTACT US FOR QUANTITY DISCOUNTS / INSTALLER / RESELLER PRICING
info@createenergy.co.za / 0118880410
Use this cable to connect a CAN-bus enabled battery, not from Victron, to a Victron system. There are two types, A and B. See the manual for details on which cable to use for which brand of batteries.
Suitable for batteries that require a Type A BMS Cable
Victron MEGA-fuse 60A/32V (package of 5 pcs)
DISCONTINUED PRODUCT, WHEN OUT OF STOCK, SELECT THE CERAMIC MODEL: https://createenergy.co.za/dc-fuses-and-fuse-holders/1334-victron-mega-fuse-300a80v-each-8719076061649.html
VE.Direct cables, use to connect BMV-70x and low power MPPTs to a Victron GX Device
The VE.Direct cable is available in different lengths. There is a straight and 90 degree angle model. Please check our pricelist for all available models.
Victron BlueSolar PWM-LCD&USB 12/24V-20A
Solar charge controller
BlueSolar PWM-LCD&USB
- Liquid Crystal Display
- Two 5 Volt USB outputs
- Lighting control function, fully programmable
- Three stage battery charging (bulk, absorption, float), fully programmable
- Load output with low voltage and manual disconnect (programmable)
- Load output protected against over load and short circuit
- Protected against reverse polarity connection of the solar panels and/or battery
BlueSolar PWM DUO-LCD&USB
All the above-mentioned functions, plus:
- Charges two separate batteries
- Programmable charge current ratio
- External Temperature sensor
CONTACT US FOR QUANTITY DISCOUNTS / INSTALLER / RESELLER PRICING
info@createenergy.co.za / 0118880410
East 1000 Watt / 1000 VA 12 V Pure Sine Wave Inverter Charger
HEAD UNIT ONLY
- High Efficiency
- Unity Power Factor
- Clean Power, Silent and Efficient
- User Configurable 10 - 40 Amp Mains Battery Charger Settings
- User Configurable Bulk / Absorption and Float Battery Charger Voltage Settings Suitable for Wet Cel, LIFePO4 AGM and Gel VRLA Batteries
- User Configurable Low Battery Alarm and Cut Off Settings
- 230 V 50 Hz Outputs
Victron SmartSolar MPPT 150/70-Tr
12V/24/48V
Solar charge controller
150VDC / 70A
12/24/48V Battery
CONTACT US FOR QUANTITY DISCOUNTS / INSTALLER / RESELLER PRICING
info@createenergy.co.za / 0118880410
Victron BatteryProtect 12/24V-100A
The BatteryProtect disconnects the battery from non essential loads before it is completely discharged (which would damage the battery) or before it has insufficient power left to crank the engine.
The BatteryProtect is a uni-directional device. It can only deal with current in one direction, so either current to a load, or current from a charger, but not both currents at the same time. In addition to this, current only can only flow from the Battery terminal to the Load terminal. In case of use with a load, the battery connects to the Battery terminal, and in case of use with a charger, the charger connects to the Battery terminal.
24V, 16A, 3 Outputs, 230VAC Input
The Blue Smart IP22 Charger is the new professional battery charger with built-in Bluetooth. The Blue Smart IP22 Charger can be used on devices in your workshop and on motor vehicles, such as (classic) cars; motorbikes; boats and camper-vans.
Use this cable to connect a CAN-bus enabled battery, not from Victron, to a Victron system. There are two types, A and B. See the manual for details on which cable to use for which brand of batteries.
Suitable for batteries that require a Type B BMS Cable
SmartSolar MPPT RS 450/200-MC4 Solar Charge Controller
New Part Number: SCC145120512
450VDC MAX Solar Array
48VDC Output
200A
11.5kW at 57.6VDC Max Charge Power
CONTACT US FOR QUANTITY DISCOUNTS / INSTALLER / RESELLER PRICING
info@createenergy.co.za / 0118880410
10mm2 Cable Size to 6mm Crimping Lug
35mm Sq DC Double Insulated Battery Cable Blue (price per m)
Mecer 3kVA Plug and Play On-line Single Phase Input and Output UPS
- 3kVA / 2700 Watt
- Internal Batteries
- Plug and Play High Frequency UPS
- On-Line Topology with built in bypass
Please contact us for quantity discounts
Email: info@createenergy.co.za or telephone: +(27) 11 888 0410
24V, 12A, 1 Output, 230VAC Input
The Blue Smart IP22 Charger is the new professional battery charger with built-in Bluetooth. The Blue Smart IP22 Charger can be used on devices in your workshop and on motor vehicles, such as (classic) cars; motorbikes; boats and camper-vans.
RS485 to USB interface to connect ET112, ET340 and EM24 to Victron GX Devices
Victron Orion-Tr 12/24-5A (120W) Isolated DC-DC converter
Remote on/off
The remote on/off eliminates the need for a high current switch in the input wiring. The remote on/off can be operated with a low power switch or by for example the engine run/stop switch (see manual).
All models are short circuit proof and can be paralleled to increase output current. An unlimited number of units can be connected in parallel.
IP43 protection
When installed with the screw terminals oriented downwards.
Screw terminals
No special tools needed for installation.
Input fuse
On 12V and 24V input models only.
Combines the functions of the MuliPlus and MultiGrid
Features of the MultiPlus, + external current transformer option to implement PowerControl & PowerAssist & to optimize self-consumption with external current sensing (max. 32A).
It also has all the features of the MultiGrid with built-in anti-islanding & an increasingly long list of country approvals.
48VDC, 10000VA, 140A Charger, 100A TS
NOTE: CAN RUN IN 3 PHASE CONFIGURATION
CANNOT BE PARALLELLED
BSL BAT Powerline 51.2V 100Ah 5KWh LIFePO4 Lithium Ion Battery
51.2V, 100Ah 5kWh
3C peak value ● Up to 81.9 kWh in Low Voltage Connection ● Real-time monitoring System and remote Debug ● Non-Toxic & Non-Hazardous Cobalt-Free LFP Chemistry ● Extended Operating Temperature -4℉ to 140℉ ● The thinnest Home ESS Ever built with just 90mm thickness ● Certification: IEC62619, CE, UL1973, UN38.3 ● Exceptional lifespan Up to 8000 Cycles ● Cycle One to Several Times Per Day ● Extended Warranty Up to 15 year
Victron SmartSolar MPPT 150/100-Tr VE.Can
12V/24/48V
Solar charge controller with VE.Can (Canbus)
150VDC / 100A
12/24/48V Battery
CONTACT US FOR QUANTITY DISCOUNTS / INSTALLER / RESELLER PRICING
info@createenergy.co.za / 0118880410
Victron Battery Monitor BMV-700 Retail
The BMV-700 is a high precision battery monitor. The essential function of a battery monitor is to calculate ampere hours consumed and the state of charge of a battery. Ampere hours consumed are calculated by integrating the current flowing in or out of the battery.
6.5 - 95V
CSB HRL12200W Sealed Lead Acid Battery
8-10 Year Design Life
12 Volts
50 Amp Hours
290W
Please contact us for quantity discounts
Email: info@createenergy.co.za or telephone: +(27) 11 888 0410
Victron Energy Energy Meter VM-3P75CT
Energy Meter 3P offers faster measurements allowing three phase ESS (Energy Saving Systems) to respond more quickly. Featuring split-coil transformers for current measurement, rather than having to be wired in series with the distribution board, the new Energy Meter saves significantly on the installation time. Units are supplied with Current Transformers. (This product is not yet available to order, but coming soon).
Victron SmartSolar MPPT 250/85-Tr VE.Can
12V/24/48V
Solar charge controller with VE.Can (Canbus)
250VDC / 85A
12/24/48V Battery
CONTACT US FOR QUANTITY DISCOUNTS / INSTALLER / RESELLER PRICING
info@createenergy.co.za / 0118880410
Wall Mount for Blue Smart IP65 Charger
This Wall Mount will be especially useful if you like to keep your smart charger handy - above your workshop bench, for example. Now the charger can be used without even moving it!
VE.Direct cables, use to connect BMV-70x and low power MPPTs to a Victron GX Device
The VE.Direct cable is available in different lengths. There is a straight and 90 degree angle model. Please check our pricelist for all available models.
The VE.Can RJ45 terminator comes in a bag of two when ordered separately. The terminators are also included with some products, for example with the CANUSB.
95mm Sq Permoweld DC Double Insulated Battery Cable Black (price per m)
95mm Sq DC Permoweld Double Insulated Battery Cable Red (price per m)
Victron BlueSolar PWM DUO-LCD&USB 12/24V-20A
Solar charge controller
BlueSolar PWM-LCD&USB
- Liquid Crystal Display
- Two 5 Volt USB outputs
- Lighting control function, fully programmable
- Three stage battery charging (bulk, absorption, float), fully programmable
- Load output with low voltage and manual disconnect (programmable)
- Load output protected against over load and short circuit
- Protected against reverse polarity connection of the solar panels and/or battery
BlueSolar PWM DUO-LCD&USB
All the above-mentioned functions, plus:
- Charges two separate batteries
- Programmable charge current ratio
- External Temperature sensor
CONTACT US FOR QUANTITY DISCOUNTS / INSTALLER / RESELLER PRICING
info@createenergy.co.za / 0118880410
Victron MultiPlus 48/1600/20-16 230V VE.Bus
The new style MultiPlus
It is a powerful true sine wave inverter, a sophisticated battery charger that features adaptive charge technology and a high-speed AC transfer switch in a single compact enclosure.
1600VA / 1300W @ 25°C
12VDC, 20A Charger, Lithium Ion battery compatible
16A Transfer Switch
230VAC